Repairing Small Cracks in Asphalt
Featured Product: Blacktop Repair Tube
- Use a scraper and/or brush to remove loose material, grass or debris from the crack.
- Once unstable material, grass or other debris has been loosened and removed from the crack.
- Use a blower to clear the repair area for an optimal repair application.
- Once the site is clean, clip the tip of the Blacktop Repair Tube and puncture through the tube spout.
- Apply a generous amount of material into the crack area.
- Before the material begins to setup, smooth out the material and remove access from the repair area.
- Allow the repair material to dry 2-3 days before allowing foot or vehicle traffic. Allow 5 days before applying sealer.
Tip: Used for repairing cracks from 1/8” to 3/8” in blacktop surfaces.
For complete product information, please refer to the product data sheet.
- Concrete & Sand Mix
- Post Setting - Round Post
- Post Setting - Square Post
- Filling a Round Hole (For Post Supports) and Filling Sakrete Form Tubes
- Polymeric Sand/Paver Set/Perma Sand
- US Cold Patch
- All Weather Black Top Patch
- Maximizer Post Setting - Round Post
- Maximizer Post Setting - Square Post
- Maximizer Filling a Round Hole and Filling Sakrete Form Tubes
- Mortar Mix
- Surface Bonding Cement
- Top'n Bond & Flo-Coat
- B-1 Leveler
Calculated results will reflect how many bags are needed for Block and Brick.
Enter the number of bricks (8" x 2" x 4") or blocks (8" x 8" x16") in the box below that you plan to use for your project. The calculator will then tell you the number of bags you need based on the different size of bags we carry.
This calculator is based on a 3/8" mortar joint. All yields are approximate and do not include an allowance for waste, uneven subgrade or any other variations from the joint size and brick and block sizes noted above.
Results will change if form of measurement is updated.