Navigating Anchoring Epoxy

If you have that loose rail, loose brick or even a void in your concrete porch or stairs the Sakrete anchoring epoxy can be used for either an indoor or outdoor repair, and we’re here to help. Even If you’re looking to securely anchor thread bar or rebar into concrete or masonry surfaces, we’ve got the heavy-duty, easy-to-use epoxy you need.


If time is of the essence but you cannot sacrifice strength, look to Sakrete Rapid Setting Anchoring Epoxy:

Quick Facts About Rapid Setting Anchoring Epoxy

  • Safe for both horizontal and vertical applications
  • Average of 15 minutes of working time at standard 75°F
  • Reaches full cure in about 10 hours
  • Ideal for vertical and horizontal applications


And, if your project requires extra strength, you can rely on Sakrete High Strength Anchoring Epoxy:

Quick Facts About High Strength Anchoring Epoxy

  • Designed for applications requiring exceptional strength
  • 30 percent greater pull-out strength than Rapid Setting Epoxy
  • Average of 28 minutes of working time at standard 75°F
  • Reaches full cure in about 24 hours


Both the Rapid Setting and High Strength Epoxies come in two-component single tubes that are applied using a standard caulking gun. Before applying the epoxy, drilled holes and surfaces should be dust free and cleaned of oil, grease and other contaminants.


###


Share:






Comments:

  • Lee-Technical Service

    06.28.2017
    Joe B, unfortunately we do no sell just the mixing nozzles. If I finish using the material l and there is unmixed epoxy in the tube, I put the original stopper back in the same way it came out and store it with my other tubes. On my next job, I attach the new nozzle to the old tube until it is empty and then finish using the new tube until the job is complete. If I have material left in that tube then I do the same thing, replace the original stopper the same way it came out and store it for the next job.
  • Joe B

    06.14.2017
    Very hard to find additional mixing nozzles for the anchoring epoxy


Leave a Comment:





Back to Blog